Pages : 1
#1 Le 09/08/2008, à 05:42
- nordinatueur
gdmsetup se ferme tout seul dès l'ouverture
Alors voilà ... Je ne suis pas un adepte du post parcequ'en général en fouinant un peu je trouve une solution sur le forum. Mais cette fois-ci je n'ai rien trouvé...
Après une réinstallation de hardy tout fonctionne comme avant (enfin pour ce que j'ai eu le temps de tester) sauf gdmsetup, le gestionnaire où on peut en particulier choisir le thème de gdm.
Lorsque la fenêtre de configuration s'ouvre elle se referme presqu'instantannément.
J'ai tenté de la lancer dans un terminal la commande
sudo gdmsetup
pour voir où était le problème mais aucune sortie n'est dirigée vers le terminal.
Si vous avez la moindre idée sur ce problème ça me serait utile.
Merci :-)
Dernière modification par nordinatueur (Le 09/08/2008, à 05:43)
Linux User #508094
Pour une meilleure coopération, utilisez des liens relatifs sur le forum !
Hors ligne
#2 Le 09/08/2008, à 05:51
- Wass
Re : gdmsetup se ferme tout seul dès l'ouverture
Crée un fichier /etc/gdm/gdm.conf-custom:
sudo gedit /etc/gdm/gdm.conf-custom
Insères-y le texte suivant, puis enregistrer et redémarre ton ordinateur:
# GDM Configuration Customization file.
#
# This file is the appropriate place for specifying your customizations to the
# GDM configuration. If you run gdmsetup, it will automatically edit this
# file for you and will cause the daemon and any running GDM GUI programs to
# automatically update with the new configuration. Not all configuration
# options are supported by gdmsetup, so to modify some values it may be
# necessary to modify this file directly by hand.
#
# To hand-edit this file, simply add or modify the key=value combination in
# the appropriate section in the template below. Refer to the comments in the
# gdm.conf file for information about each option. Also refer to the reference
# documentation.
#
# If you hand edit a GDM configuration file, you should run the following
# command to get the GDM daemon to notice the change. Any running GDM GUI
# programs will also be notified to update with the new configuration.
#
# gdmflexiserver --command="UPDATE_CONFIG <configuration key>"
#
# For example, the "Enable" key in the "[debug]" section would be specified by
# "debug/Enable".
#
# You can also run gdm-restart or gdm-safe-restart to cause GDM to restart and
# re-read the new configuration settings. You can also restart GDM by sending
# a HUP or USR1 signal to the daemon. HUP behaves like gdm-restart and causes
# any user session started by GDM to exit immediately while USR1 behaves like
# gdm-safe-restart and will wait until all users log out before restarting GDM.
#
# For full reference documentation see the gnome help browser under
# GNOME|System category. You can also find the docs in HTML form on
# http://www.gnome.org/projects/gdm/
#
# NOTE: Lines that begin with "#" are considered comments.
#
# Have fun![daemon]
[security]
[xdmcp]
[gui]
[greeter]
[chooser]
[debug]
[servers]
Ca devrait être bon.
Brainstorm: Partager les votes données aux chansons avec les autres utilisateurs de Rhythmbox
Brainstorm: Plus qu'un seul champs artiste dans Rhythmbox
SAYERH Wassim, Utilisateur marocain d'Ubuntu.
Hors ligne
#3 Le 09/08/2008, à 14:56
- nordinatueur
Re : gdmsetup se ferme tout seul dès l'ouverture
En effet j'avais ces 3 lignes en plus entre [greeter] et [chooser]
...
[greeter]
SoundOnLoginFile=
DefaultFace=
GlobalFaceDir=///
[chooser]
...
Mais cela ne change rien à mon problème : les lignes reviennent au (re-)démarrage
Y a-t-il un moyen de modifier moi-même un fichier sans passer par gdmsetup ?
Dernière modification par nordinatueur (Le 09/08/2008, à 14:59)
Linux User #508094
Pour une meilleure coopération, utilisez des liens relatifs sur le forum !
Hors ligne
#4 Le 10/08/2008, à 00:26
- nordinatueur
Re : gdmsetup se ferme tout seul dès l'ouverture
Bon au début je pensais que je pourrais m'en passer mais j'ai fini par réinstaller (pour le temps que ça prend... )
Merci quand même pour ton soutien.
[Edit :] N'empêche que ça reste une question intéressante... Alors si quelqu'un a une réponse, qu'il n'hésite pas à se manifester ...
Dernière modification par nordinatueur (Le 10/08/2008, à 00:28)
Linux User #508094
Pour une meilleure coopération, utilisez des liens relatifs sur le forum !
Hors ligne
Pages : 1