Pages : 1
#1 Le 28/09/2010, à 16:01
- JeepBCN
mise au propre de mon probleme de connexion WIFI
Je crois préférable de repartir sur des bases plus saines et légères concernant mon probleme de connection wifi.
Pour ceux que cele peut intéresser:
http://forum.ubuntu-fr.org/viewtopic.php?id=419258
Mais tout d'abord:
cat /etc/lsb-release
DISTRIB_ID=Ubuntu
DISTRIB_RELEASE=9.10
DISTRIB_CODENAME=karmic
DISTRIB_DESCRIPTION="Ubuntu 9.10"
lsusb
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 003: ID 148f:2770 Ralink Technology, Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
lspci
00:00.0 RAM memory: nVidia Corporation MCP61 Memory Controller (rev a1)
00:01.0 ISA bridge: nVidia Corporation MCP61 LPC Bridge (rev a2)
00:01.1 SMBus: nVidia Corporation MCP61 SMBus (rev a2)
00:01.2 RAM memory: nVidia Corporation MCP61 Memory Controller (rev a2)
00:02.0 USB Controller: nVidia Corporation MCP61 USB Controller (rev a3)
00:02.1 USB Controller: nVidia Corporation MCP61 USB Controller (rev a3)
00:04.0 PCI bridge: nVidia Corporation MCP61 PCI bridge (rev a1)
00:05.0 Audio device: nVidia Corporation MCP61 High Definition Audio (rev a2)
00:06.0 IDE interface: nVidia Corporation MCP61 IDE (rev a2)
00:07.0 Bridge: nVidia Corporation MCP61 Ethernet (rev a2)
00:08.0 IDE interface: nVidia Corporation MCP61 SATA Controller (rev a2)
00:0d.0 VGA compatible controller: nVidia Corporation C61 [GeForce 6150SE nForce 430] (rev a2)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
lspci -nn | grep -i net
00:07.0 Bridge [0680]: nVidia Corporation MCP61 Ethernet [10de:03ef] (rev a2
sudo lshw -C network
00:07.0 Bridge [0680]: nVidia Corporation MCP61 Ethernet [10de:03ef] (rev a2)
jean@gerard:~$ sudo lshw -C network
[sudo] password for jean:
*-network
description: Wireless interface
physical id: 1
logical name: ra0
serial: 00:1d:1a:04:89:a9
capabilities: ethernet physical wireless
configuration: broadcast=yes multicast=yes wireless=RT2870 Wireless
lsmod
Module Size Used by
binfmt_misc 10220 1
snd_hda_codec_realtek 277860 1
rt2870sta 545720 1
snd_hda_intel 31976 2
snd_hda_codec 87584 2 snd_hda_codec_realtek,snd_hda_intel
snd_hwdep 9384 1 snd_hda_codec
snd_pcm_oss 44704 0
snd_mixer_oss 18976 1 snd_pcm_oss
snd_pcm 93160 3 snd_hda_intel,snd_hda_codec,snd_pcm_oss
snd_seq_dummy 3460 0
amd64_edac_mod 26688 0
snd_seq_oss 33440 0
snd_seq_midi 8192 0
ppdev 8232 0
snd_rawmidi 27296 1 snd_seq_midi
snd_seq_midi_event 8448 2 snd_seq_oss,snd_seq_midi
snd_seq 60608 6 snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_seq_midi_event
snd_timer 26992 2 snd_pcm,snd_seq
snd_seq_device 8308 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_rawmidi,snd_seq
snd 77160 16 snd_hda_codec_realtek,snd_hda_intel,snd_hda_codec,snd_hwdep,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_seq_oss,snd_rawmidi,snd_seq,snd_timer,snd_seq_device
parport_pc 37352 1
k8temp 5504 0
edac_core 48876 1 amd64_edac_mod
nvidia 8098608 38
iptable_filter 3872 0
i2c_nforce2 8168 0
psmouse 58020 0
serio_raw 6596 0
soundcore 9088 1 snd
snd_page_alloc 10928 2 snd_hda_intel,snd_pcm
ip_tables 21200 1 iptable_filter
x_tables 25832 1 ip_tables
lp 11908 0
parport 40528 3 ppdev,parport_pc,lp
dm_raid45 78504 0
xor 5456 1 dm_raid45
forcedeth 61292 0
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
ra0 RT2870 Wireless ESSID:"11n-AP" Nickname:"RT2870STA"
Mode:Auto Frequency=2.412 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s
RTS thr:off Fragment thr:off
Link Quality=10/100 Signal level:0 dBm Noise level:-97 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ifconfig
eth0 Link encap:Ethernet HWaddr 00:1f:d0:3d:6e:d5
inet adr:192.168.1.10 Bcast:192.168.1.255 Masque:255.255.255.0
adr inet6: fe80::21f:d0ff:fe3d:6ed5/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Packets reçus:40520 erreurs:0 :0 overruns:0 frame:0
TX packets:40320 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
Octets reçus:10463416 (10.4 MB) Octets transmis:4695347 (4.6 MB)
Interruption:24 Adresse de base:0xe000
lo Link encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
Packets reçus:8 erreurs:0 :0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
Octets reçus:480 (480.0 B) Octets transmis:480 (480.0 B)
ra0 Link encap:Ethernet HWaddr 00:1d:1a:04:89:a9
adr inet6: fe80::21d:1aff:fe04:89a9/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Packets reçus:0 erreurs:0 :0 overruns:0 frame:0
TX packets:2800 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
Octets reçus:0 (0.0 B) Octets transmis:223216 (223.2 KB)
ra0:avahi Link encap:Ethernet HWaddr 00:1d:1a:04:89:a9
inet adr:169.254.6.207 Bcast:169.254.255.255 Masque:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
sudo iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
ra0 No scan results
uname -r -m
2.6.31-22-generic x86_64
cat /etc/network/interfaces
auto lo
iface lo inet loopback
auto ra0
iface ra0 inet dhcp
J'utilise Wicd en tant que gestionnaire de réseau
La box est une Livebox mini thomson CFA6
La clé wifi usb est une Ovislink Evo-300USB
selon le site du fabricant elle utilise le chipset rt2872sta au sujet duquel existe une doc:
http://doc.ubuntu-fr.org/wifi_chipset_rt2870
Sur le site de Ralink,j'ai trouvé x drivers dont:
file:///home/jean/2009_0521_RT2870_Linux_STA_V2.1.2.0
et
file:///home/jean/2009_0918_RT2860_Linux_STA_v2.2.0.0
le 1er comporte un patch qui semble adapté au noyau:
file:///home/jean/2009_0521_RT2870_Linux_STA_V2.1.2.0/rt2870-2.6.31-compile.patch
Mais je n'arrive pas à le patcher, voir ci dessous:
jean@gerard:~$ cd /home/jean/2009_0521_RT2870_Linux_STA_V2.1.2
jean@gerard:~/2009_0521_RT2870_Linux_STA_V2.1.2.0$ patch -p0 < 2.6.31-compile.patch
bash: 2.6.31-compile.patch: Aucun fichier ou dossier de ce type
jean@gerard:~/2009_0521_RT2870_Linux_STA_V2.1.2.0$ patch -p0 < rt2870-2.6.31-compile.patch
can't find file to patch at input line 5
Perhaps you used the wrong -p or --strip option?
The text leading up to this was:
--------------------------
|--- NEW FILE rt2870-2.6.31-compile.patch ---
|diff -rupN 2009_0521_RT2870_Linux_STA_V2.1.2.0.old/include/rtmp_os.h 2009_0521_RT2870_Linux_STA_V2.1.2.0/include/rtmp_os.h
|--- 2009_0521_RT2870_Linux_STA_V2.1.2.0.old/include/rtmp_os.h 2009-04-23 05:40:41.000000000 -0400
|+++ 2009_0521_RT2870_Linux_STA_V2.1.2.0/include/rtmp_os.h 2009-08-02 19:46:07.000000000 -0400
--------------------------
File to patch: /home/jean/2009_0521_RT2870_Linux_STA_V2.1.2.0
patch: **** File /home/jean/2009_0521_RT2870_Linux_STA_V2.1.2.0 is not a regular file -- can't patch
Merci pour votre aide
Mult-Boot W 8.1. LM17Cinnamon.Ubuntu 14.04
AMD Athlon 64X2 / DD To / MM 2Go DDR2
Hors ligne
Pages : 1