Ubuntu-fr

grigouille

partage scanner ubuntu 16.04

Bonjour,

J'ai toujours réussi à partager mon scanner  (https://doc.ubuntu-fr.org/tutoriel/util … _en_reseau)
mais avec la 16.04, cela ne fonctionne pas :
serveur xubuntu 16.04 64 bit

scanner : laserjet m1132 MFP correctement installé (via hp-setup -iax)

$ ifconfig | grep 'inet adr'
          inet adr:192.168.1.11  Bcast:192.168.1.255  Masque:255.255.255.0
          inet adr:127.0.0.1  Masque:255.0.0.0

$ scanimage -L
device `hpaio:/usb/HP_LaserJet_Professional_M1132_MFP?serial=000000000QH2222PPR1a' is a Hewlett-Packard HP_LaserJet_Professional_M1132_MFP all-in-one

$ grep saned /etc/group
lp:x:7:saned
scanner:x:122:saned
saned:x:127:

$ cat /etc/default/saned 
# Defaults for the saned initscript, from sane-utils

# To enable under systemd please read README.Debian
# Set to yes to start saned under SysV
RUN=yes

# Set to the user saned should run as
RUN_AS_USER=saned$ cat  /etc/sane.d/saned.conf
# saned.conf
# Configuration for the saned daemon

## Daemon options
# Port range for the data connection. Choose a range inside [1024 - 65535].
# Avoid specifying too large a range, for performance reasons.
#
# ONLY use this if your saned server is sitting behind a firewall. If your
# firewall is a Linux machine, we strongly recommend using the
# Netfilter nf_conntrack_sane connection tracking module instead.
#
# data_portrange = 10000 - 10100


## Access list
# A list of host names, IP addresses or IP subnets (CIDR notation) that
# are permitted to use local SANE devices. IPv6 addresses must be enclosed
# in brackets, and should always be specified in their compressed form.
#
# The hostname matching is not case-sensitive.

#scan-client.somedomain.firm
#192.168.0.1
#192.168.0.1/29
192.168.1.0/24
#[2001:db8:185e::42:12]
#[2001:db8:185e::42:12]/64

# NOTE: /etc/inetd.conf (or /etc/xinetd.conf) and
# /etc/services must also be properly configured to start
# the saned daemon as documented in saned(8), services(4)
# and inetd.conf(4) (or xinetd.conf(5)).

$ service saned status
● saned.service
   Loaded: masked (/dev/null; bad)
   Active: inactive (dead)

Le serveur a été rebouté. Le scan fonctionne en local.

---

Debian (xfce) 12
HP LaserJet M1132 MFP

grigouille

Re : partage scanner ubuntu 16.04

sur le client xubuntu 16.04 64 bits :

$ cat /etc/sane.d/net.conf 
# This is the net backend config file.

## net backend options
# Timeout for the initial connection to saned. This will prevent the backend
# from blocking for several minutes trying to connect to an unresponsive
# saned host (network outage, host down, ...). Value in seconds.
# connect_timeout = 60
192.168.1.11

## saned hosts
# Each line names a host to attach to.
# If you list "localhost" then your backends can be accessed either
# directly or through the net backend.  Going through the net backend
# may be necessary to access devices that need special privileges.
# localhost

$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).

$ ifconfig | grep 'inet adr'
          inet adr:127.0.0.1  Masque:255.0.0.0
          inet adr:192.168.1.23  Bcast:192.168.1.255  Masque:255.255.255.0

Le client a aussi été rebouté.

Merci pour votre aide.

---

Debian (xfce) 12
HP LaserJet M1132 MFP

grigouille

Re : partage scanner ubuntu 16.04

Il semble normal que cela ne fonctionne pas :
https://help.ubuntu.com/community/SaneD … untu_15.04

---

Debian (xfce) 12
HP LaserJet M1132 MFP