Pages : 1
#1 Le 28/06/2016, à 09:57
- freeman32
Problème wifi Banana-pi M2+
Bonjour à tous je viens d'acquérir un Banana-pi M2+ et j'ai installé dessus une version serveur et j'ai un petit problème pour me connecter avec le wifi.
Tous d'abord je vois que l'interface wlan0 ne s'allume pas au démarrage et je ne sais pas comment faire pour que ce soit le cas.
Ensuite j'essaie de me connecter à ma freebox révolution mais sans succès, j'ai chercher un peu partout sur la toile les différents tuto que j'ai pu trouver mais rien à faire.
Voici un screen de mon fichier interfaces :
https://www.dropbox.com/s/n6d0t7e6wi626 … 0.jpg?dl=0
>> cat /etc/lsb-release
>> lsusb
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
>> lspci -k -nn | grep -A 3 -i net
>> sudo lshw -C network
>> lsmod
Module Size Used by
bcmdhd 648477 0
hidp 12949 0
rfcomm 32863 0
hci_uart 20384 0
bluetooth 174065 5 hidp,hci_uart,rfcomm
>> iwconfig
wlan0 IEEE 802.11 Access Point: Not-Associated
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
p2p0 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
>> ifconfig -a
eth0 Link encap:Ethernet HWaddr fa:4a:19:3a:45:4f
inet addr:192.168.0.16 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::f84a:19ff:fe3a:454f/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1254 errors:0 dropped:0 overruns:0 frame:0
TX packets:1080 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:162997 (159.1 KiB) TX bytes:125649 (122.7 KiB)
Interrupt:114
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:25 errors:0 dropped:0 overruns:0 frame:0
TX packets:25 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2568 (2.5 KiB) TX bytes:2568 (2.5 KiB)
p2p0 Link encap:Ethernet HWaddr 00:90:4c:33:22:11
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
tunl0 Link encap:IPIP Tunnel HWaddr
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 00:90:4c:11:22:33
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
>> sudo iwlist scan
>> uname -r -m
3.4.112-sun8i armv7l
>> cat /etc/network/interfaces
# Wired adapter #1
allow-hotplug eth0
iface eth0 inet dhcp
# hwaddress ether # if you want to set MAC manually
# pre-up /sbin/ifconfig eth0 mtu 3838 # setting MTU for DHCP, static just: mtu 3838
# Wired adapter #2
#allow-hotplug eth1
#iface eth1 inet dhcp
# hwaddress ether # if you want to set MAC manually
# pre-up /sbin/ifconfig eth0 mtu 3838 # setting MTU for DHCP, static just: mtu 3838
# Wireless adapter #1
#allow-hotplug wlan0
#auto wlan0
#iface wlan0 inet static
# wpa-ssid La Bourdette
# wpa-key-mgmt WPA-PSK
# wpa-group CCMP
# wpa-psk 07061987
# address 192.168.0.10
# netmask 255.255.255.0
# gateway 192.168.0.254
# dns-nameservers 192.168.0.254
# to generate proper encrypted key: wpa_passphrase yourSSID yourpassword
# Local loopback
auto lo
iface lo inet loopback
>> nm-tool
>> nmcli dev wifi
>> nmcli connection show
>> sudo rfkill list
0: sunxi-bt: Bluetooth
Soft blocked: yes
Hard blocked: no
1: phy0: Wireless LAN
Soft blocked: no
Hard blocked: no
2: brcmfmac-wifi: Wireless LAN
Soft blocked: no
Hard blocked: no
Merci d'avance pour vos réponses et bonne journée !
Dernière modification par freeman32 (Le 29/06/2016, à 17:58)
Hors ligne
#2 Le 29/06/2016, à 17:59
- freeman32
Re : Problème wifi Banana-pi M2+
Ajout du log
Hors ligne
Pages : 1