Contenu | Rechercher | Menus

Annonce

Si vous avez des soucis pour rester connecté, déconnectez-vous puis reconnectez-vous depuis ce lien en cochant la case
Me connecter automatiquement lors de mes prochaines visites.

À propos de l'équipe du forum.

#1 Le 24/11/2008, à 14:35

Raghnarok

[résolu] rTorrent et partage des fichiers terminés

Bonjour.

J'ai utilisé l'option de rTorrent qui permet de déplacer les torrents terminés. Malheureusement quand cela est fait je ne diffuse plus les fichiers...

Je vous met mon rtorrent.rc :

# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.

# Maximum and minimum number of peers to connect to per torrent.
#min_peers = 40
#max_peers = 100

# Same as above but for seeding completed torrents (-1 = same as downloading)
#min_peers_seed = 10
#max_peers_seed = 50

# Maximum number of simultanious uploads per torrent.
#max_uploads = 15

# Global upload and download rate in KiB. "0" for unlimited.
download_rate = 0
upload_rate = 25

# Default directory to save the downloaded torrents.
directory = /media/documents/downloads/incoming/

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = /media/documents/downloads/session

# Watch a directory for new torrents, and stop those that have been
# deleted.
schedule = watch_directory,5,5,load_start=/media/documents/downloads/torrents/*.torrent
schedule = untied_directory,5,60,stop_untied=

# Close torrents when diskspace is low.
#schedule = low_diskspace,5,60,close_low_diskspace=100M

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

# Port range to use for listening.
#port_range = 6890-6999

# Start opening ports at a random position within the port range.
#port_random = no

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
#check_hash = no

# Set whetever the client should try to connect to UDP trackers.
use_udp_trackers = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
# encryption = allow_incoming,enable_retry,prefer_plaintext

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
# The default is "off". For DHT to work, a session directory must be defined.
# 
# dht = auto

# UDP port to use for DHT. 
# 
# dht_port = 6881

# Enable peer exchange (for torrents not marked private)
#
# peer_exchange = yes

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10

key_layout="qwertz"

# Move completed downloads
on_finished = move_complete,"execute=mv,-u,$d.get_base_path=,/media/documents/downloads/completed/ ;d.set_directory=/media/documents/completed/"

Voila... J'aimerai donc pouvoir continuer à partager même si ils sont dans le dossier "completed". Si quelqu'un sait comment faire...


Merci d'avance.

Dernière modification par Raghnarok (Le 24/11/2008, à 16:02)


Feisty/XP Desktop ( Pentium D 3.00 GHz, 2Go DDR2 800, GeForce 7600GT )
Hardy Laptop ( Centrino 2 Duo 2.00 Ghz, 2Go DDR2 667, Nvidia FX350M )

Hors ligne

#2 Le 24/11/2008, à 14:49

Raghnarok

Re : [résolu] rTorrent et partage des fichiers terminés

Comme quoi le fait de l'écrire résout bien des problèmes...

J'ai mal écris ma commande...
Le d.set_directory est /media/documents/downloads/completed et non /media/documents/completed ...

On peut se sentir con parfois tongue

Mais le ridicule ne tue pas.


Merci ^^


Feisty/XP Desktop ( Pentium D 3.00 GHz, 2Go DDR2 800, GeForce 7600GT )
Hardy Laptop ( Centrino 2 Duo 2.00 Ghz, 2Go DDR2 667, Nvidia FX350M )

Hors ligne