Pages : 1
#1 Le 21/01/2009, à 17:27
- K0k4
Problème Wi-Fi Broadcom Corp.
Bonjour à tous.
Comme vous pouvez le supposez j'ai un problème de wifi. Et voilà les réponses de mon Linux 8.0.4 LTS (Hardy) au commandes que je lui transmet.
fantom@Fantom:~$ cat /ect/lsb-release
cat: /ect/lsb-release: Aucun fichier ou dossier de ce type
fantom@Fantom:~$ lsusb
Bus 006 Device 004: ID 0781:5406 SanDisk Corp. Cruzer Micro 4GB Flash Drive
Bus 006 Device 001: ID 0000:0000
Bus 005 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 004: ID 08ff:2580 AuthenTec, Inc.
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000fantom@Fantom:~$ lspci
00:00.0 Host bridge: ATI Technologies Inc RS690 Host Bridge
00:01.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (Internal gfx)
00:04.0 PCI bridge: ATI Technologies Inc Unknown device 7914
00:05.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (PCI Express Port 1)
00:06.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (PCI Express Port 2)
00:12.0 SATA controller: ATI Technologies Inc SB600 Non-Raid-5 SATA
00:13.0 USB Controller: ATI Technologies Inc SB600 USB (OHCI0)
00:13.1 USB Controller: ATI Technologies Inc SB600 USB (OHCI1)
00:13.2 USB Controller: ATI Technologies Inc SB600 USB (OHCI2)
00:13.3 USB Controller: ATI Technologies Inc SB600 USB (OHCI3)
00:13.4 USB Controller: ATI Technologies Inc SB600 USB (OHCI4)
00:13.5 USB Controller: ATI Technologies Inc SB600 USB Controller (EHCI)
00:14.0 SMBus: ATI Technologies Inc SBx00 SMBus Controller (rev 14)
00:14.1 IDE interface: ATI Technologies Inc SB600 IDE
00:14.2 Audio device: ATI Technologies Inc SBx00 Azalia
00:14.3 ISA bridge: ATI Technologies Inc SB600 PCI to LPC Bridge
00:14.4 PCI bridge: ATI Technologies Inc SBx00 PCI to PCI Bridge
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
01:05.0 VGA compatible controller: ATI Technologies Inc RS690M [Radeon X1200 Series]
02:04.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev b6)
02:04.1 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 02)
10:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5787M Gigabit Ethernet PCI Express (rev 02)
30:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 02)fantom@Fantom:~$ sudo lshw -C network
*-network
description: Ethernet interface
product: NetLink BCM5787M Gigabit Ethernet PCI Express
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:10:00.0
logical name: eth0
version: 02
serial: 00:1a:4b:65:3f:4b
capacity: 1GB/s
width: 64 bits
clock: 33MHz
capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.86 latency=0 link=no module=tg3 multicast=yes port=twisted pair
*-network
description: Network controller
product: BCM94311MCG wlan mini-PCI
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:30:00.0
version: 02
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: driver=b43-pci-bridge latency=0 module=ssb
*-network DISABLED
description: Wireless interface
physical id: 1
logical name: wlan0
serial: 00:00:00:1a:73:7f
capabilities: ethernet physical wireless
configuration: broadcast=yes multicast=yes wireless=IEEE 802.11gfantom@Fantom:~$ iwconfig
lo no wireless extensions.eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:""
Mode:Managed Channel:0 Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0fantom@Fantom:~$ sudo iwlist scan
lo Interface doesn't support scanning.eth0 Interface doesn't support scanning.
wmaster0 Interface doesn't support scanning.
wlan0 Interface doesn't support scanning : Network is down
fantom@Fantom:~$ uname -r -m
2.6.24-19-generic i686fantom@Fantom:~$ cat /ect/network/interfaces
cat: /ect/network/interfaces: Aucun fichier ou dossier de ce typefantom@Fantom:~$ nm-tool
NetworkManager ToolState: disconnected
- Device: wlan0 ----------------------------------------------------------------
NM Path: /org/freedesktop/NetworkManager/Devices/wlan0
Type: 802.11 Wireless
Driver:
Active: no
HW Address: 00:00:00:1A:73:7FCapabilities:
Supported: yesWireless Settings
Scanning: yes
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yesWireless Networks (* = Current Network)
- Device: eth0 ----------------------------------------------------------------
NM Path: /org/freedesktop/NetworkManager/Devices/eth0
Type: Wired
Driver: tg3
Active: no
HW Address: 00:1A:4B:65:3F:4BCapabilities:
Supported: yes
Carrier Detect: yesWired Settings
Hardware Link: nofantom@Fantom:~$
Je vous remercie d'avance de votre aide.
#2 Le 24/01/2009, à 15:58
- K0k4
Re : Problème Wi-Fi Broadcom Corp.
Alors ?
Pages : 1