Pages : 1
#1 Le 02/11/2006, à 20:23
- Thierry_68
Remplacer Grub par Lilo
Bonjour, comment je viens de désinstaller grub et d'installer lilo grace a synaptic...
Il faut maintenant que je configure lilo, sachant que j'ai une partition windows, l'autre linux.
Lorsque je tape "sudo liloconfig", il me met cela :
LILO, the LInux LOader, sets up your system to boot Linux directly
from your hard disk, without the need for a boot floppy.
WARNING!
Your /etc/fstab configuration file gives device UUID=39ae4c8b-2aec-4abc-8532-253ebada6f62 as the root
filesystem device. This doesn't look to me like an "ordinary" block
device. Either your fstab is broken and you should fix it, or you are
using hardware (such as a RAID array) which this simple configuration
program does not handle.
You should either repair the situation or hand-roll your own
/etc/lilo.conf configuration file; you can then run /usr/sbin/liloconfig
again to retry the configuration process.
Documentation for LILO can be found in /usr/share/doc/lilo/.
que dois-je faire ?
merci pour vos conseils
#2 Le 31/01/2007, à 22:49
- Agone
Re : Remplacer Grub par Lilo
c'est pas une histoire de UUID ?
Hors ligne