Pages : 1
#1 Le 28/09/2012, à 16:50
- xunil2003
Modifier l'adresse IP
Bonjour,
Je suis sous Kubuntu 12.04 X86_64.
Quand je veux changer mon adresse ip en modifiant le fichier /etc/network/interfaces
et le modifiant avec ceci
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth1
iface eth1 inet static
address 192.168.0.4
netmask 255.255.255.0
gateway 192.168.0.254
auto eth1
puis quand je redémarre mon pc , je vois les postes avec nmap 192.168.0.0-255 sur mon réseau mais je n'est pas internet dans le navigateur firefox, alors qu'avant ça marché avec
laurent@PC-ubuntu:~$ cat /etc/network/interfaces
auto lo
iface lo inet loopback
laurent@PC-ubuntu:~$
Quand je ping sur la freebox ça marche.
Quelle erreur est je fais ?
Y a-t-il plusieurs fichiers à configurer ?
Je n'ai pas trouvé dans quel fichier indiquer le DNS 1 et 2 ?
Merci.
Dernière modification par xunil2003 (Le 28/09/2012, à 16:51)
- AMD R9 5950x 64 Go Ram / Intel Pentium I7 960 - 12 Go Ram - 6 T0 - Kubuntu 12.04 x64 / Kubuntu 14.04 x64 / Kubuntu 16.04 x64 / Kubuntu 18.04 x64 / Kubuntu 20.04 x64 / Mint
- DreamPlug Multi Boot / Marvel 1.22 Ghz / Architecture ARM / 512 Mo Ram / Carte-sd 16 Go class 10 / 5 Watts / Debian Squeeze 2.6.39.4
- Raspberry PI 1 / Raspberry PI 2 / Raspberry PI 3 / Raspberry PI 4 : 4Gb
JE SUIS CHARLIE
Hors ligne
#2 Le 28/09/2012, à 17:04
- Beta Pictoris
Re : Modifier l'adresse IP
Dans /etc/resolv.conf:
man resolv.conf
Dernière modification par Beta Pictoris (Le 28/09/2012, à 17:04)
Hors ligne
#3 Le 28/09/2012, à 19:34
- xunil2003
Re : Modifier l'adresse IP
Bonjour
J'ai ajouté les adresses dns dans le fichier "/etc/resolv.conf" comme ceci
laurent@PC-ubuntu:~$ cat /etc/resolv.conf
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8)
# DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8)
# DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
nameserver 212.27.40.240
nameserver 212.27.40.241
laurent@PC-ubuntu:~$
Quand je redémarre le service réseau il me dit qu'il y a une faille
laurent@PC-ubuntu:~$ sudo /etc/init.d/networking restart
* Running /etc/init.d/networking restart is deprecated because it may not enable again some interfaces
* Reconfiguring network interfaces... RTNETLINK answers: File exists
Failed to bring up eth1.
[ OK ]
laurent@PC-ubuntu:~$
et quand je redémarre le pc il n'y a pas Internet pourtant quand je ping les ip du réseau ça marche ?????
Ou est mon erreur ?
Merci.
- AMD R9 5950x 64 Go Ram / Intel Pentium I7 960 - 12 Go Ram - 6 T0 - Kubuntu 12.04 x64 / Kubuntu 14.04 x64 / Kubuntu 16.04 x64 / Kubuntu 18.04 x64 / Kubuntu 20.04 x64 / Mint
- DreamPlug Multi Boot / Marvel 1.22 Ghz / Architecture ARM / 512 Mo Ram / Carte-sd 16 Go class 10 / 5 Watts / Debian Squeeze 2.6.39.4
- Raspberry PI 1 / Raspberry PI 2 / Raspberry PI 3 / Raspberry PI 4 : 4Gb
JE SUIS CHARLIE
Hors ligne
#4 Le 28/09/2012, à 19:36
- Beta Pictoris
Re : Modifier l'adresse IP
Fait un "ifconfig"
Dernière modification par Beta Pictoris (Le 28/09/2012, à 19:36)
Hors ligne
#5 Le 28/09/2012, à 20:05
- xunil2003
Re : Modifier l'adresse IP
Bonjour,
ça marche comme ceci :
/etc/network/interfaces
laurent@PC-ubuntu:~$ cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth1
iface eth1 inet static
address 192.168.0.4
netmask 255.255.255.0
gateway 192.168.0.254
auto eth1
laurent@PC-ubuntu:~$
/etc/resolv.conf
laurent@PC-ubuntu:~$ cat /etc/resolv.conf
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8)
# DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
nameserver 212.27.40.240
nameserver 212.27.40.241
laurent@PC-ubuntu:~$
puis redémarrage du réseau
laurent@PC-ubuntu:~$ sudo /etc/init.d/networking restart
* Running /etc/init.d/networking restart is deprecated because it may not enable again some interfaces
* Reconfiguring network interfaces... [ OK ]
laurent@PC-ubuntu:~$
Vérification
laurent@PC-ubuntu:~$ ifconfig eth1
eth1 Link encap:Ethernet HWaddr bc:ae:c5:33:64:33
inet adr:192.168.0.4 Bcast:192.168.0.255 Masque:255.255.255.0
adr inet6: fe80::beae:c5ff:fe33:6433/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Packets reçus:659 erreurs:0 :0 overruns:0 frame:0
TX packets:514 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
Octets reçus:188996 (188.9 KB) Octets transmis:83042 (83.0 KB)
Interruption:19 Adresse de base:0xc00
laurent@PC-ubuntu:~$ cat /etc/resolv.conf
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8)
# DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
nameserver 212.27.40.240
nameserver 212.27.40.241
laurent@PC-ubuntu:~$
Internet fonctionne.
Merci.
- AMD R9 5950x 64 Go Ram / Intel Pentium I7 960 - 12 Go Ram - 6 T0 - Kubuntu 12.04 x64 / Kubuntu 14.04 x64 / Kubuntu 16.04 x64 / Kubuntu 18.04 x64 / Kubuntu 20.04 x64 / Mint
- DreamPlug Multi Boot / Marvel 1.22 Ghz / Architecture ARM / 512 Mo Ram / Carte-sd 16 Go class 10 / 5 Watts / Debian Squeeze 2.6.39.4
- Raspberry PI 1 / Raspberry PI 2 / Raspberry PI 3 / Raspberry PI 4 : 4Gb
JE SUIS CHARLIE
Hors ligne
#6 Le 28/09/2012, à 20:43
- xunil2003
Re : Modifier l'adresse IP
Bonjour,
Je remarque que le fichier /etc/resolv.conf ce vide des adresse dns à chaque redémarrage du pc ?
Pourquoi ?
Je suis obligé a chaque redémarrage de remettre dans le fichier les adresse dns puis de faire
sudo /etc/init.d/networking restart
Comment faire ?
Merci.
Dernière modification par xunil2003 (Le 28/09/2012, à 20:45)
- AMD R9 5950x 64 Go Ram / Intel Pentium I7 960 - 12 Go Ram - 6 T0 - Kubuntu 12.04 x64 / Kubuntu 14.04 x64 / Kubuntu 16.04 x64 / Kubuntu 18.04 x64 / Kubuntu 20.04 x64 / Mint
- DreamPlug Multi Boot / Marvel 1.22 Ghz / Architecture ARM / 512 Mo Ram / Carte-sd 16 Go class 10 / 5 Watts / Debian Squeeze 2.6.39.4
- Raspberry PI 1 / Raspberry PI 2 / Raspberry PI 3 / Raspberry PI 4 : 4Gb
JE SUIS CHARLIE
Hors ligne
#7 Le 28/09/2012, à 20:59
- Beta Pictoris
Re : Modifier l'adresse IP
Désactiver le service resolvconf:
cd /etc/init
sudo mv resolvconf.conf resolvconf.conf.disabled
Dernière modification par Beta Pictoris (Le 28/09/2012, à 21:05)
Hors ligne
#8 Le 28/09/2012, à 22:03
- xunil2003
Re : Modifier l'adresse IP
Bonsoir
ça ne marche pas quand je fait :
cd /etc/init
sudo mv resolvconf.conf resolvconf.conf.disabled
puis redémarrage du pc, Pas de connection internet.
En attendent pour avoir internet j'ai du tout faire
cd /etc/init
sudo mv resolvconf.conf.disabled resolvconf.conf
rebooter le pc puis
sudo echo "nameserver 212.27.40.240" >> /etc/resolv.conf
sudo echo "nameserver 212.27.40.241" >> /etc/resolv.conf
sudo /etc/init.d/networking restart
Merci
Dernière modification par xunil2003 (Le 29/09/2012, à 07:36)
- AMD R9 5950x 64 Go Ram / Intel Pentium I7 960 - 12 Go Ram - 6 T0 - Kubuntu 12.04 x64 / Kubuntu 14.04 x64 / Kubuntu 16.04 x64 / Kubuntu 18.04 x64 / Kubuntu 20.04 x64 / Mint
- DreamPlug Multi Boot / Marvel 1.22 Ghz / Architecture ARM / 512 Mo Ram / Carte-sd 16 Go class 10 / 5 Watts / Debian Squeeze 2.6.39.4
- Raspberry PI 1 / Raspberry PI 2 / Raspberry PI 3 / Raspberry PI 4 : 4Gb
JE SUIS CHARLIE
Hors ligne
Pages : 1