Contenu | Rechercher | Menus

Annonce

Si vous rencontrez des soucis à rester connecté sur le forum (ou si vous avez perdu votre mot de passe) déconnectez-vous et reconnectez-vous depuis cette page, en cochant la case "Me connecter automatiquement lors de mes prochaines visites". Attention, le forum rencontre actuellement quelques difficultés. En cas d'erreur 502, il ne faut pas re-valider l'envoi d'un message ou l'ouverture d'une discussion, au risque de créer un doublon.

La section divers se réorganise ! De nouvelles sous-sections à venir. (plus d'infos + donner son avis)

#1 Le 02/12/2012, à 12:03

tux4fun

hdparm.conf Failed to set et Hitachi HTS541612J9SA00 sur Asus F3Jv022p

Bonjour,

Impossible de faire prendre des paramètres, à chaque redémarrage /etc/hdparm.conf failed . Je trouve relativement lent, les taux retourné par hdparm,  comment optimiser ce disque, toute tentative se solde par un failed ?
Les taux de transfert minable:

hdparm -Tt /dev/sda

/dev/sda:
 Timing cached reads:   5446 MB in  2.00 seconds = 2728.79 MB/sec
 Timing buffered disk reads: 114 MB in  3.02 seconds =  37.70 MB/sec
root@formula1:/home/tux4fun# hdparm -Tt /dev/sda

/dev/sda:
 Timing cached reads:   5264 MB in  2.00 seconds = 2636.67 MB/sec
 Timing buffered disk reads: 114 MB in  3.00 seconds =  37.95 MB/sec

Mon fichier /etc/hdparm.conf est vierge de toute modifs, puisque  la cousine Debian ne veux pas en entendre parler...

Les fichiers relatifs aux disque en questions:

Le controleur :

00:1f.2 IDE interface: Intel Corporation 82801GBM/GHM (ICH7-M Family) SATA Controller [IDE mode] (rev 02)
sudo hdparm -I /dev/sda

[sudo] password for tux4fun: 

/dev/sda:

ATA device, with non-removable media
	Model Number:       Hitachi HTS541612J9SA00                 
	Serial Number:      SB2D01E4G7W0PB
	Firmware Revision:  SBDOC70P
Standards:
	Used: ATA/ATAPI-7 T13 1532D revision 1 
	Supported: 7 6 5 4 
Configuration:
	Logical		max	current
	cylinders	16383	16383
	heads		16	16
	sectors/track	63	63
	--
	CHS current addressable sectors:   16514064
	LBA    user addressable sectors:  234441648
	LBA48  user addressable sectors:  234441648
	Logical/Physical Sector size:           512 bytes
	device size with M = 1024*1024:      114473 MBytes
	device size with M = 1000*1000:      120034 MBytes (120 GB)
	cache/buffer size  = 7516 KBytes (type=DualPortCache)
Capabilities:
	LBA, IORDY(can be disabled)
	Queue depth: 32
	Standby timer values: spec'd by Vendor, no device specific minimum
	R/W multiple sector transfer: Max = 16	Current = 16
	Advanced power management level: 254
	Recommended acoustic management value: 128, current value: 254
	DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5 
	     Cycle time: min=120ns recommended=120ns
	PIO: pio0 pio1 pio2 pio3 pio4 
	     Cycle time: no flow control=120ns  IORDY flow control=120ns
Commands/features:
	Enabled	Supported:
	   *	SMART feature set
	    	Security Mode feature set
	   *	Power Management feature set
	   *	Write cache
	   *	Look-ahead
	   *	Host Protected Area feature set
	   *	WRITE_BUFFER command
	   *	READ_BUFFER command
	   *	NOP cmd
	   *	DOWNLOAD_MICROCODE
	   *	Advanced Power Management feature set
	    	Power-Up In Standby feature set
	   *	SET_FEATURES required to spinup after power up
	    	SET_MAX security extension
	    	Automatic Acoustic Management feature set
	   *	48-bit Address feature set
	   *	Device Configuration Overlay feature set
	   *	Mandatory FLUSH_CACHE
	   *	FLUSH_CACHE_EXT
	   *	SMART error logging
	   *	SMART self-test
	   *	General Purpose Logging feature set
	   *	WRITE_{DMA|MULTIPLE}_FUA_EXT
	   *	64-bit World wide name
	   *	IDLE_IMMEDIATE with UNLOAD
	   *	Gen1 signaling speed (1.5Gb/s)
	   *	Native Command Queueing (NCQ)
	   *	Host-initiated interface power management
	   *	Phy event counters
	    	Non-Zero buffer offsets in DMA Setup FIS
	    	DMA Setup Auto-Activate optimization
	   *	Device-initiated interface power management
	    	In-order data delivery
	   *	Software settings preservation
Security: 
	Master password revision code = 65534
		supported
	not	enabled
	not	locked
	not	frozen
	not	expired: security count
	not	supported: enhanced erase
	72min for SECURITY ERASE UNIT. 
Logical Unit WWN Device Identifier: 5000cca51ec39409
	NAA		: 5
	IEEE OUI	: 000cca
	Unique ID	: 51ec39409
Checksum: correct
sudo hdparm -i /dev/sda

/dev/sda:

 Model=Hitachi HTS541612J9SA00, FwRev=SBDOC70P, SerialNo=SB2D01E4G7W0PB
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=DualPortCache, BuffSize=7516kB, MaxMultSect=16, MultSect=16
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=234441648
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4 
 DMA modes:  mdma0 mdma1 mdma2 
 UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 
 AdvancedPM=yes: mode=0x80 (128) WriteCache=enabled
 Drive conforms to: ATA/ATAPI-7 T13 1532D revision 1:  ATA/ATAPI-2,3,4,5,6,7
sudo hdparm -i /dev/sda

/dev/sda:

 Model=Hitachi HTS541612J9SA00, FwRev=SBDOC70P, SerialNo=SB2D01E4G7W0PB
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=DualPortCache, BuffSize=7516kB, MaxMultSect=16, MultSect=16
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=234441648
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4 
 DMA modes:  mdma0 mdma1 mdma2 
 UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 
 AdvancedPM=yes: mode=0x80 (128) WriteCache=enabled
 Drive conforms to: ATA/ATAPI-7 T13 1532D revision 1:  ATA/ATAPI-2,3,4,5,6,7

Dernière modification par tux4fun (Le 02/12/2012, à 12:04)


tux4fun
http://linuxcounter.net/ - http://frederick.varin.free.fr
Linux Registered User     #363458
Machine Registered     #261921

Hors ligne

#2 Le 03/12/2012, à 19:03

tux4fun

Re : hdparm.conf Failed to set et Hitachi HTS541612J9SA00 sur Asus F3Jv022p

En modifiant /etc/modules et en y collant ata_piix, pas très concluant:

sudo hdparm -tT /dev/sda
[sudo] password for tux4fun: 

/dev/sda:
 Timing cached reads:   4936 MB in  2.00 seconds = 2472.94 MB/sec
 Timing buffered disk reads:  84 MB in  3.03 seconds =  27.70 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   5476 MB in  2.00 seconds = 2743.77 MB/sec
 Timing buffered disk reads:  88 MB in  3.01 seconds =  29.26 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   5400 MB in  2.00 seconds = 2705.14 MB/sec
 Timing buffered disk reads:  84 MB in  3.04 seconds =  27.64 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   5420 MB in  2.00 seconds = 2715.81 MB/sec
 Timing buffered disk reads: 114 MB in  3.00 seconds =  37.98 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   4994 MB in  2.00 seconds = 2501.91 MB/sec
 Timing buffered disk reads: 114 MB in  3.00 seconds =  37.96 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   4868 MB in  2.00 seconds = 2438.27 MB/sec
 Timing buffered disk reads: 114 MB in  3.01 seconds =  37.93 MB/sec
tux4fun@formula1:~$ sudo hdparm -tT /dev/sda

/dev/sda:
 Timing cached reads:   5454 MB in  2.00 seconds = 2732.80 MB/sec
 Timing buffered disk reads: 114 MB in  3.01 seconds =  37.93 MB/sec

Dernière modification par tux4fun (Le 03/12/2012, à 19:04)


tux4fun
http://linuxcounter.net/ - http://frederick.varin.free.fr
Linux Registered User     #363458
Machine Registered     #261921

Hors ligne

Haut de page ↑