Ubuntu-fr

ludox

Lecteur de cartes memoire. XD ok mais SD ne semble pas reconnue...

Bonjour,

J'ai acheté un lecteur de carte ALL in 1 capable de lire un paquet de cartes mémoires sur port usb 2.0.

Je suis sous Ubuntu Breezy en mode installation base serveur + personnalisation.

J'ai deux types de cartes mémoire à lire. Ma carte XD est reconnue mais ma carte SD ne le semble pas.

Voilà ce que me donne Dmesg dans les deux cas :

Si je met ma carte xd dans le lecteur et que je branche celui-ci :

[4295449.651000] usb 6-4: new high speed USB device using ehci_hcd and address 2
[4295449.906000] SCSI subsystem initialized
[4295449.919000] Initializing USB Mass Storage driver...
[4295449.926000] scsi0 : SCSI emulation for USB Mass Storage devices
[4295449.927000] usb-storage: device found at 2
[4295449.927000] usb-storage: waiting for device to settle before scanning
[4295449.928000] usbcore: registered new driver usb-storage
[4295449.928000] USB Mass Storage support registered.
[4295454.928000]   Vendor: Generic   Model: USB SD Reader     Rev: 1.00
[4295454.928000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295454.936000]   Vendor: Generic   Model: USB CF Reader     Rev: 1.01
[4295454.936000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295454.944000]   Vendor: Generic   Model: USB SM Reader     Rev: 1.02
[4295454.944000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295454.952000]   Vendor: Generic   Model: USB MS Reader     Rev: 1.03
[4295454.952000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295454.960000] usb-storage: device scan complete
[4295455.240000] Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
[4295455.278000] Attached scsi removable disk sdb at scsi0, channel 0, id 0, lun 1
[4295455.825000] SCSI device sdc: 1024000 512-byte hdwr sectors (524 MB)
[4295455.826000] sdc: Write Protect is off
[4295455.826000] sdc: Mode Sense: 03 00 00 00
[4295455.826000] sdc: assuming drive cache: write through
[4295455.830000] SCSI device sdc: 1024000 512-byte hdwr sectors (524 MB)
[4295455.831000] sdc: Write Protect is off
[4295455.831000] sdc: Mode Sense: 03 00 00 00
[4295455.831000] sdc: assuming drive cache: write through
[4295455.832000]  /dev/scsi/host0/bus0/target0/lun2: p1
[4295455.973000] Attached scsi removable disk sdc at scsi0, channel 0, id 0, lun 2
[4295455.977000] Attached scsi removable disk sdd at scsi0, channel 0, id 0, lun 3

et donc ensuite :

ludo@ubuntu1:~$ ls /dev/sd*
/dev/sda  /dev/sdb  /dev/sdc  /dev/sdc1  /dev/sdd

On voit bien que sdc1 à été créé dans /dev et je peux monter a carte xd par là.

Par contre si je branche mon lecteur de carte avec ma carte sd dedans, voilà ce que donne dmesg :

[4295643.151000] usb 6-4: new high speed USB device using ehci_hcd and address 3
[4295643.233000] scsi1 : SCSI emulation for USB Mass Storage devices
[4295643.235000] usb-storage: device found at 3
[4295643.235000] usb-storage: waiting for device to settle before scanning
[4295648.236000]   Vendor: Generic   Model: USB SD Reader     Rev: 1.00
[4295648.236000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295648.617000] SCSI device sda: 29120 512-byte hdwr sectors (15 MB)
[4295648.618000] sda: Write Protect is off
[4295648.618000] sda: Mode Sense: 03 00 00 00
[4295648.618000] sda: assuming drive cache: write through
[4295648.622000] SCSI device sda: 29120 512-byte hdwr sectors (15 MB)
[4295648.623000] sda: Write Protect is off
[4295648.623000] sda: Mode Sense: 03 00 00 00
[4295648.623000] sda: assuming drive cache: write through
[4295648.623000]  /dev/scsi/host1/bus0/target0/lun0:<6>Device sda not ready.
[4295648.625000] end_request: I/O error, dev sda, sector 0
[4295648.625000] Buffer I/O error on device sda, logical block 0
[4295648.626000] Device sda not ready.
[4295648.626000] end_request: I/O error, dev sda, sector 0
[4295648.626000] Buffer I/O error on device sda, logical block 0
[4295648.627000]  unable to read partition table
[4295648.627000] Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
[4295648.629000]   Vendor: Generic   Model: USB CF Reader     Rev: 1.01
[4295648.629000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295648.636000] Attached scsi removable disk sdb at scsi1, channel 0, id 0, lun 1
[4295648.638000]   Vendor: Generic   Model: USB SM Reader     Rev: 1.02
[4295648.638000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295648.644000] Attached scsi removable disk sdc at scsi1, channel 0, id 0, lun 2
[4295648.680000]   Vendor: Generic   Model: USB MS Reader     Rev: 1.03
[4295648.680000]   Type:   Direct-Access                      ANSI SCSI revision: 00
[4295648.688000] Attached scsi removable disk sdd at scsi1, channel 0, id 0, lun 3
[4295648.695000] usb-storage: device scan complete

et :

ludo@ubuntu1:~$ ls /dev/sd*
/dev/sda  /dev/sdb  /dev/sdc  /dev/sdd

Et là je ne vois pas comment monter ma carte sd.

Voilà, j'avais le projet de m'acheter un lecteur mp3 sd card mais je vais être trés embêté si je suis incapable de télécharger les titres.

Merci de votre aide.

---

LudoX
-----------------------------------------

-----------------------------------------